It's time I started another Figure!
This is Misono Misono. Apparently from the PC Visual Novel: Iro ni Ide ni Keri Waga Koi wa. I don't know anything about the character or source material, but looks to be based on this drawing:
Quite a small box.
17 pieces, seems about 1:7 scale
Fairly straight forward looking.
Trimming some mold lines from the feet..
..and the inside of the leg joint.
Shoulder has a tab where the mold was probably poured.
Same on this elbow.
Leg fit is pretty good already.
You can just about make out a bubble here just under the surface of the shoulder (and several other places)
A light sanding would break the surface of the bubble and leave an unpleasant pit.
I've lightly drilled out the bubbles, ready to be filled with putty later.
Drilling some holes for pin joints. This is a 1.5mm drill bit.
The front portion of the hair comes in parts and doesn't fit together very well.
I've pinned it here with 1.5mm aluminium wire
And glued with a two part 15min epoxy.
Wings and face parts are pinned and glued.
Left arm taped in place
Right arm temporarily attached
Right hand pinned and glued for a better angle to grip the other arm.
